stayer CM230K Manual De Instrucciones página 14

- Clean up with a magnetic chip collector and a chip
hook or other appropriate tool.
- CAUTION: NEVER position machine on a work
piece between the electrode and the ground of
any arc type welder. Damage to the machine will
result, as the welder will ground through the
machine's ground cable.
- WARNING: NEVER attempt to use machine
with incorrect current or abnormally low
voltage. Check machine nameplate to ensure
that correct voltage and Hz are used.
FUNCTIONAL DESCRIPTION
These machines are Dry-Cut Metal Cutting Circular Saws
designed to cut ferrous metals. This saw uses blades that
are rated for 3700 rpm or higher.
Retain all packing materials until after you have inspected
and satisfactorily operated the machine.
Carton contents:
- Metal Cutting Saw
- Rip Fence Cutting Guide
- Hex Wrench
- Manual of instructions
Do not operate this tool until you read and understand the
entire instruction manual.
REMOVING THE BLADE
disconnect tool from power source.
1. Push in the arbor lock and using the supplied hex
wrench, rotate the blade until the lock engages the
blade arbor. See fig.2.
2. While holding the blade lock lever, use the provided
wrench to loosen the blade retaining bolt. Then
remove it and the outer arbor flange.
3. The blade may now be carefully removed.
INSTALLING THE BLADE
ensure that tool is disconnected from power source.
1. Remove any accumulated debris in the guards and
around the arbor.
2. Orient the flange so that the correct bore size faces
the blade and place the new blade on the arbor,
making sure that the teeth point forwards.
3. Place the outer arbor flange on the arbor with the
flat side toward the blade. See fig.3.
4. Replace and finger-tighten the blade retaining bolt
by turning it clockwise.
ENGLISH
10
TO ADJUST DEPTH OF CUT
(disconnect tool from power source)
1. Lift the depth lock lever at the rear of the saw. See
fig.4.
2. Raise or lower the saw base until the blade extends
the desired depth below the base.
3. Press the depth lock lever down firmly, locking the
saw in the selected position.
TO ADJUST BEVEL ANGLE
(disconnect tool from power source)
To adjust the bevel angle, refer to the bevel guage on the
base. There are markings for different angles from 0 to 45
degrees. To adjust the bevel angle:Loosen the bevel lock
knob (See fig.5) and the smaller knob at the rear. Lift the
bevel lock knob out of the slot and rotate the base to the
desired angle. Then tighten the smaller knob at the rear of
the base.
HOW TO USE THE SIGHTING NOTCH
To aid in free-hand cutting, a sighting notch is located at the
front of the base. See fig. 6 Align the cutting line on the
workpiece with the sighting notch. Make the cut. Use the
righthand notch (between the two marking dots) for straight
cuts and the left-hand notch (located below the rivet) for 45
degree bevel cuts.
STARTING AND STOPPING TOOL
Make sure that the power circuit voltage is the same as that
shown on the specification plate of the machine.
To start the machine, first press the safety lock button then
squeeze the trigger switch to start the motor.
Release the trigger switch to stop the motor. See fig.7
REMOVING CHIPS
(disconnect machine from power source)
This dry-cut metal saw has an internal chip collector. First
shut down and disconnect tool from power source.
The outer blade cover lock knob has a bayonet lock thread.
See fig.8 To remove cover, turn knob anticlockwise while
pushing in against the spring tension. Then lift cover away.
Take care when removing the cover to keep the chips or
shavings away from your hands or other body parts. To
replace the outer blade cover, line up tang with slot and
push in against the spring while turning clockwise. Ensure
that the cover is properly seated.
10