Braun FlexXP System 5691 Manual Del Usuario página 10

from the cartridge. Slide the cartridge into
the base as far as it will go.
• Slowly close the housing by pushing it down
until it locks.
Replacing the cartridge
After having pressed the lift button to open the
housing, wait for a few seconds before
removing the used cartridge.
Before discarding the used cartridge, make
sure to close the openings using the lid of the
new cartridge, since the used cartridge will
contain contaminated cleaning solution.
The used cartridge can be disposed in the
household waste.
Operating your
Clean&Charge
• Connect your Clean&Charge with the
special cord set to the mains electricity
supply. The special socket at the back is
adjustable to save space. After each shave,
switch the shaver off and put it into the
Clean&Charge, upside down and with the
front showing.
• Push the start/release button (3) to lock and
connect the shaver. The cleaning process
will start (approx. 5 minutes cleaning,
4 hours drying).
• Do not interrupt the cleaning process, as it
leaves the shaver wet and not fit for use. If
interruption is needed nonetheless, press
the start/release button (3).
• After 4 hours the process is finished and the
shaver is ready for use.
To release it, push the start/release button.
• A cleaning cartridge should be sufficient
for about 30 cleaning cycles. When the level
indicator (4) has reached the «min» mark,
the remaining fluid in the cartridge is suffi-
cient for about 5 more cleaning cycles. Then
the cartridge should be replaced, when
used daily approx. every 4 weeks.
• The hygienic cleaning solution cartridge
contains alcohol which, once opened,
will naturally evaporate slowly into the
surrounding air. Each cartridge, if not used
daily should be replaced after approx.
8 weeks.
• Clean the housing from time to time with a
damp cloth, especially the opening where
the shaver rests.
Subject to change without notice.
This product conforms to the
EMC-Directive 89/336/EEC and to the
Low Voltage Regulation (73/23 EEC).
Electric specifications see printing on the
special cord set.
11