English; Charging The Shaver - Braun FlexXP System 5691 Manual Del Usuario

English

A Shaver
Our products are designed to meet the
highest standards of quality, functionality and
design. We hope you enjoy your new Braun
shaver.
Warning
Your shaver is provided with a special cord
set with integrated Safety Extra Low Voltage
power supply. Do not exchange or manipulate
any part of it. Otherwise there is a risk of
electric shock.
Description
1 Foil protection cap
2 Shaver foil
3 Cutter block
4 Release button
5 On/off switch («start/stop»)
6 Long hair trimmer
7 Charging light (green)
8 Special cord set

Charging the shaver

• Using the special cord set, charge the shaver
directly off the mains for at least 4 hours
(shaver and special cord set might get warm).
• With normal use the shaver will be charged
automatically after every cleaning in the
Clean&Charge (see section B).
• The green charging light indicates that the
shaver is being charged.
• A full charge will give up to 40 minutes of
cordless shaving time depending on your
beard growth. However, the maximum
battery capacity will only be reached after
several charging/discharging cycles.
• Best environmental temperature range for
charging is 15 °C to 35 °C.
• When fully discharged, you may also shave
with the shaver connected to the mains via
the special cord set.
Shaving
Turn on the shaver («start»):
The pivoting cutting system automatically
adjusts to every contour of your face.
Trimmer:
When the long hair trimmer is activated, it
allows the controlled trimming of moustache
or sideburns.
Tips for the perfect shave
• We recommend that you shave before
washing, as the skin tends to be slightly
swollen after washing.
• Hold the shaver at right angles (90°) to the
skin. Stretch the skin and shave against
the direction of beard growth.
• To maintain 100% shaving performance,
replace your foil and cutter block every
18 months or when worn.
Keeping your shaver in top
shape
Automatic cleaning
Your shaver should be cleaned daily in the
Clean&Charge.
Once the shaver is put into in the
Clean&Charge, it is cleaned automatically (see
section B). Manual cleaning is recommended
only when the Clean&Charge is not available,
e.g. when travelling.
Manual cleaning
Always unplug the appliance before cleaning.
Remove the shaver foil (shaver head must be
in central position) and, using the brush, clean
the cutter block and the inner area of the
shaver head. Do not clean the shaver foil with
the brush.
When cleaning the shaver under running
water, make sure it is completely dry before
putting it into the Clean&Charge.
9