ETI Solid State Lighting RK-72-850-MV-D Guía De Uso Y Cuidado página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

installation - strip Lights (continued)
7
wiring the Shunted Sockets
□ Push the solid copper jumper wires (AA and BB) into the holes on the shunted sockets (C).
□ Add sockets depending on the type of connection mode.
C
AA
AA or BB
BB
Connection Modes
4 Tube Tandem/Parallel Installation With Ballast Removed
L
N
LED lamp
LED lamp
LED lamp
LED lamp
L
N
L
C
AA or BB
BB
2 Tube Tandem Installation With Ballast Removed
L
N
LED lamp
LED lamp
N
L
N
L
6
installation - strip Lights (continued)
8
Installing the wired Sockets
□ Push the shunted sockets (C) through the proper holes in the brackets (B) until they snap into place. For 8-ft. Strip Lights that
require the center section, two (2) shunted sockets (C) will be back-to-back when installed correctly.
8-fT. STRIP LIGHTS
BB
AA
AA
BB
AA
BB
9
Mounting the Retrofit Brackets
N
□ Install the two (2) end brackets (B) and secure
them using the self tapping screws (CC).
□ For 8-ft. Strip Lights, verify the proper
placement of the center bracket by using
an actual 4-ft. LED linear tube (A) to check
the distance between brackets (B) before
securing the center section with the self-
tapping screws (CC).
nOTe: Use center bracket for 8-ft. Strip
Lights only.
C
BB
AA
B
B
B
BB
BB
AA
BB
C
AA
B
B
BB
AA
AA
BB
C
B
AA
B
C
B
C
CC
C
7
4-fT. STRIP LIGHTS
C
B
AA
BB
AA
C
AA
BB
C
B
AA
B
C
C
C
B
C
CC
CC
CC
www.ETiSSL.CoM
Please contact 1-855-384-7754 or further assistance.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Rk-72-840-mv-d

Tabla de contenido