Escalade Sports Stiga Play The Best T8521 El Manual Del Propietario página 5

5. Lay Table Top (#1) painted side down, on a smooth, flat surface. Use the shipping
container to protect the painted surface of table top.
6. Align the "U" Support (#21) on Table Top (#1) as shown in Figure 5.
7. Align all four holes in each U-Clip (#22) with the four Indentations in table top.
Be sure that Slot in the Three U-Clips (#22) all face the same direction toward the
end of the table with no stripe and no Indentations. Secure U-Clips (#22) with
Screws (#5) as shown in Figure 5 & Detail A.
Note: All four holes in the U-Clip (#22) must align with four Indentations
in table top. See Detail A.
Note: Indentations in table top are small so look closely.
21
22
Slot in
U-Clip
Detail A
8. Rotate U-support (#21) that is on bottom of Table Top
until you see the screw holes in the slots of U-clips (#22).
If necessary Slide U-support (#21) side to side and back
and forth to see holes. See Figure 5 & Detail B.
Note: To aid in assembly you can use a cordless drill and
Phillips bit for Step 9 only. Wear safety glasses.
9. Insert Screw (#35) through slot in U-clip (#22) and into U-support
(#21). See Figure 5 & Detail B. Thread screw all the way into U-
support until it touches the back of the tube. There should be about
3/8" of screw (#35) left sticking out. Repeat for second Screw (#35)
and U Clip (#22).
Note: All Indentations
guides in table top are
small so look closely.
5
WHEN ASSEMBLING TABLE, IT IS EXTREMELY IMPORTANT THAT THE U-
CLIPS (#22) BE TURNED AS SHOWN HERE. IF U-CLIPS ARE TURNED
INCORRECTLY, YOU WILL DO IRREPARABLE DAMAGE TO YOUR TABLE
WHEN YOU ATTEMPT TO OPEN IT TO THE PLAYING POSITION.
1
Figure 5
Note: End with no stripe
and no Indentations.
5
CAUTION:
35
Detail B
21
22
If you want to see a video on how to insert Screw (#35) go to:
http://www.escaladesports.com/customer-service/videos.html
Or
Scan with your smartphone: