Charging; Operation - Silvercrest SAS 7.4 LI B3 Instrucciones De Uso

Charging

NOTE
► Check to ensure that the on/off switch 6 has been pushed back (to the
position "0 ) before starting the charging process .
■ Place the handheld vacuum cleaner from above into the wall bracket 3 so
that the barrel plug 5 slips into the socket on the handheld vacuum cleaner .
The charge indicator lamp 7 lights up red and the charging process begins .
Important: The charge indicator lamp 7 lights up green once the handheld
■
vacuum cleaner is charged enough to vacuum again . This does not mean that
all the batteries are completely charged . When the charge indicator lamp 7
lights up green, the batteries are charged to around 80% .
■ When charging is complete, which can take around 5 hours with fully dis-
charged batteries, the appliance automatically switches to a trickle charge
(maintenance function) . Nevertheless, in order to avoid possible damage
to the batteries, do not leave the appliance permanently connected to the
mains adapter 4 .
■ Do not recharge the batteries again until the handheld vacuum cleaner's
suction power becomes appreciably weaker and the charge indicator lamp 7
flashes green .
NOTE
► The handheld vacuum cleaner can also be charged directly via the mains
adapter 4 . To do this, remove the barrel plug 5 with a slight twist from the
wall bracket 3 and insert it into the socket on the handheld vacuum cleaner .

Operation

CAUTION!
► The suction opening must always be open and may not be blocked . Block-
ages lead to overheating and damage to the motor .
NOTICES
► Make certain that the dust filter 0 is always inserted before using the
appliance .
► When vacuuming liquid, do not exceed the MAX marking in dirt container q .
■ 20 │ GB │ IE SAS 7.4 LI B3