Cleaning - Silvercrest SAS 7.4 LI B3 Instrucciones De Uso

1) Remove the handheld vacuum cleaner from the wall bracket 3 or, if you are
not using the wall bracket 3 remove the barrel plug 5 from the socket .
2) If required, place the appropriate nozzle in the suction opening:
–
the crevice nozzle 2, to clean narrow and difficult to reach locations .
–
the wet suction nozzle 1 to vacuum up liquids .
NOTE
► After you have vacuumed up liquids, immediately clean the dirt container q .
Otherwise, bacteria or mould will build up inside! Ensure that the dust filter
bag 9 is completely dry before using the appliance again .
3) To switch the appliance on, slide the on/off switch 6 forwards . The charge
indicator lamp 7 lights up green .
4) When you have finished using the appliance, slide the on/off switch 6 to
the rear .
NOTE
► Place the handheld vacuum cleaner in the wall bracket 3 and start the
charging process once the vacuum power has become noticeably weaker
and the charge indicator lamp 7 flashes green .

Cleaning

To achieve the best results, empty the dirt container q and clean the dust filter 0
after every use .
CAUTION! MATERIAL DAMAGE!
► Do not use aggressive, chemical or abrasive cleaning agents . These could
damage the outer surfaces of the appliance .
1) To open the dirt container q, press the release button 8 and remove the
dirt container q .
2) Remove the dust filter 0 from the dirt container q .
3) Empty the dirt container q .
4) Pull the dust filter bag 9 with its holder out of the dust filter 0 .
5) Rinse the dust filter bag 9 out in cold water and wait until it is completely
dry before reinserting it into the dust filter 0 . Do not dry it with hot air .
6) Reinsert the dust filter 0 into the dirt container q . When doing so, ensure
that the dust filter 0 is seated squarely and that the rubber lip seals the dirt
container q .
SAS 7.4 LI B3 GB │ IE │ 21 ■