Publicidad
3.
Remove the wall plate template
CAUTION:
Be sure the anchors C1 are seated flush with the concrete surface.
using two lag bolts C3 and two washers C2 (use only the lag bolts and washers from the Concrete
4.
Install wall plate
15
Installation Kit*). Tighten the lag bolts C3 only until the washers C2 are pulled firmly against the wall plate.
NOTE:
If needed, you can make small level adjustments to the wall plate by loosening the bottom lag bolt C3 and shifting
the wall plate until level. Tighten the bottom lag bolt C3 when adjustments are complete (see page 13).
CAUTION:
Avoid potential personal injury or property damage! All lag bolts MUST BE firmly tightened to prevent
unwanted movement of the wall plate
next step.
3
and insert two anchors C1
14
. Ensure the wall plate is securely fastened to the wall before continuing on to the
15
C1
(Fischer UX 10 x 60 - included in the Concrete Installation Kit*see page 6).
4
15
C3
C2
15
Publicidad
