VONROC S-WC501AC Serie Traducción Del Manual Original página 8

EN
Cutting disc
Diameter:
Bore:
Spindle thread
Protection class
Weight
Sound pressure L
PA
Acoustic power L
WA
Uncertainty (K)
Vibration (main grip)
Vibration (auxiliary grip)
Uncertainty (K)
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2 - 4.
1. On/off switch
2. Lock-off button
3. Locking knob for slot depth
4. Scale for slot depth
5. Spindle lock button
6. Guard
7. Base
8. Guide roller
9. Dust extraction connection
10. Main grip
11. Auxiliary grip
8
150mm
22.2mm
M12
IP20
5.1kg
85.3 dB(A)
96.3 dB(A)
3 dB(A)
7.214 m/s
2
5.843 m/s
2
1.5 m/s
2
12. Allen screws
13. Allen key
14. Spindle
15. Outer flange
16. Flange key
17. Cutting disc
18. Spacers
19. Cutting disc
20. Spindle sleeve
21. Inner flange
22. Dust extraction adapter
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Replacing the cutting discs (fig. B ­ D)
Worn or damaged cutting discs must be replaced
immediately.
- Only use sharp and undamaged cutting
discs.
- Only use cutting discs that are suitable
for the material to be worked.
- Only use cutting discs with a maximum
permitted speed that is equal to or
exceeds the maximum no-load speed
of the machine.
- Only use diamond cutting discs that are
suitable for dry cutting.
- Always replace both cutting discs at the
same time.
- Never attempt to remove the guard.
• Place the machine on a stable surface.
• Loosen the Allen screws (12) using the Allen
key (13).
• Loosen the locking knob (3) and lower the base
(7).
• Remove the guard (6).
• Keep the spindle lock button (5) pressed to lock
the spindle (14).
• Loosen the outer flange (15) using the flange
key (16). To untighten, turn clockwise. To tighten,
turn anti-clockwise.
• Remove the old cutting disc (17), the spacers
(18), the old cutting disc (19), the spindle
sleeve (20), and the inner flange (21).
• If necessary, clean the flanges (15 & 21).
WWW.VONROC.COM