Sauder 408363 Manual Del Usuario página 10

Step 5 Step
Separate the EXTENSION SLIDES (GG) from the EXTENSION
å
RAILS (FF) as shown in the upper diagram below. Be prepared,
the parts are greasy.
Fasten two EXTENSION RAILS (FF) to the EXTENSION
å
BLOCKS (I). Use four GOLD 5/16" FLAT HEAD SCREWS (WW).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
å
shown in the enlarged diagram. Then, slide the inner cartridge
of the EXTENSION RAIL out to fi nd the other hole that lines up
with the hole in the EXTENSION BLOCK. Turn a SCREW into
this hole.
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
Notched edge
Open end
Page 10
GG
Push the release lever in and pull the SLIDE from the RAIL.
WW
FF
I
408363
FF
Notched edge
Open end
FF
I
Hole
www.sauder.com/services