Silverline 103597 Traducción Del Manual Original página 7

103597
Welding
WARNING: Using a welder correctly is a technical skill . An incorrectly-used welder can be highly
dangerous. The information below is general guidance only. If you are not entirely confident in your
ability to use this tool safely DO NOT USE .
1 . Move the On/Off Switch (2) into the 'I' position (located at rear of welder)
2 . Hold the Electrode Clamp (10) in one hand, and the Welding Mask (13) in the other
3. Position the rod at an angle of approximately 80˚ to the surface, with the tip approximately
30mm away from the metal
4 . Hold the Welding Mask over your face and tap the rod against the metal
5 . An arc should strike between the metal and the tip . Try to maintain a distance between the
welding rod and the workpiece equivalent to the diameter of the rod. Maintain the arc for one-to-
two seconds, then move the rod away
6 . Allow the weld to cool slightly and move the mask away from your face . If the settings were
correct, a round 'spot' weld should have formed
7 . If the weld has not fully penetrated the metal, increase the current setting . If a hole has been
made in the metal, reduce the current setting
8. Practice making 'spot' welds until you are confident in using the machine and selecting settings
9 . In order to form a 'seam' weld, maintain the arc for longer, and slowly move the rod along the
path of the join. The speed at which the rod is moved is crucial to achieving a good weld
• If the machine settings are correct, the arc should be steady, and should produce a crackling
sound . Be aware that you will have to gradually move the electrode clamp closer to the metal
as the rod is used up
• Once the weld bead is complete, remove excess and splatters using a chipping hammer or wire
brush . Do not attempt to weld over beads unless properly cleaned
• Creating neat, high quality welds is a skill that takes time to master. Practice and good
preparation will help to make satisfactory welds
Accessories
A range of other accessories and consumables, including Welders Helmet, Welders Chipping
Hammer, Welders Apron and Welders Gauntlets, is available from your Silverline stockist . Spare
parts can be obtained from toolsparesonline .com
Maintenance
WARNING: ALWAYS disconnect from the power supply before carrying out any inspection,
maintenance or cleaning .
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear . Repairs should be
carried out by an authorised Silverline service centre . This advice also applies to extension cords
used with this tool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the machine's service life . Clean the body of your machine with a soft brush, or dry cloth .
If available, use clean, dry, compressed air to blow through the ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent . Do not use alcohol, petrol
or strong cleaning agents
• Never use caustic agents to clean plastic parts
200A MMA Inverter Arc Welder Kit
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair .
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
silverlinetools.com
7