Adjust Oven Burners - Frigidaire FGGF3685TS Manual De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

36" GAS RANGE INSTALLATION INSTRUCTIONS
10
Adjusting Oven Burners
10.1
Electric Ignition Burners
Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks, and range has been connected to
electric power. The oven burner is equipped with an
electric control system as well as an electric oven burner
igniter. If your model is equipped with a waist-high broil
burner igniter, it will also have an electric burner igniter.
These control systems require no adjustment. When
the oven is set to operate, current will flow to the igniter.
It will "glow" similar to a light bulb. When the igniter
has reached a temperature sufficient to ignite gas, the
electrically controlled oven valve will open and flame will
appear at the oven burner. There is a time lapse from
30 to 60 seconds after thermostat is turned ON before
the flame appears at the oven burner. When the oven
reaches the display setting, the glowing igniter will go
off. The burner flame will go "out" in 20 to 30 seconds
after igniter goes "OFF". To maintain any given oven
temperature, this cycle will continue as long as the
display is set to operate.
After removing all packing materials and literature from
the oven:
1. Set the oven to BAKE at 300°F. See Use & Care
Guide for operating instructions.
2. Within 60 seconds the oven burner should ignite.
Check for proper flame (see 10.2), and allow the
burner to cycle once. Reset controls to off.
3. If your model is equipped with a waist-high broiler
burner, set oven to broil. See Use & Care Guide for
operating instructions.
4. Within 60 seconds the broil burner should ignite.
Check for proper flame. Reset controls to off.
Lower
Oven Burner
Baffle
(removable)
Figure 23: Oven Burners
Waist-High Burner
Air Shutter
Lower Oven
Bottom
removable)
Air Shutter
10.2
Oven Burner Flame Adjustment
The approximate oven burner flame length is 1 inch
(distinct inner cone of blue flame).
To determine if the oven burner flame is proper, remove
the oven bottom and burner baffle and set the oven to
bake at 300°F.
To remove the oven bottom, remove the oven racks
and the ladder racks. Slide the oven bottom forward to
disengage the back tab. Lift and slide back to disengage
front of oven bottom from oven front frame. Pull the oven
bottom out of the cavity. The baffle is attached to the
oven bottom and requires no further disassembly.
If the flame is yellow, increase air shutter opening size
(see "2" in Figure 24). If the entire flame is blue, reduce
the air shutter opening size.
To adjust flame loosen lock screw (see "3" in Figure 24),
reposition air shutter, and tighten lock screw. Replace
oven bottom.
3
Lock Screw
2
Air Shutter
Figure 24: Oven Burner Adjustments
10.3
Broil Burner Flame Adjustment
The approximate flame length of the burner is 1 inch
(distinct inner cone of blue flame). To determine if the
broil burner flame is proper, set the oven to broil. If flame
is yellow, increase air shutter opening size (see "2" in
Figure 24). If the entire flame is blue, reduce the air
shutter opening size. To adjust, loosen lock screw (see
"3" in Figure 24), reposition air shutter, and tighten lock
screw.
15
Oven Burner Tube
1
Orifice Hood

Publicidad

Tabla de contenido
loading

Tabla de contenido