Cabinet Dimensions - Frigidaire FGGF3685TS Manual De Instalación

36" GAS RANGE INSTALLATION INSTRUCTIONS

Cabinet Dimensions

Clearances and Dimensions
• Provide adequate clearances between the appliance and adjacent combustible surfaces.
• Location - Check location where the appliance will be installed. Check for proper electrical supply and floor
stability.
• Dimensions shown must be used. Given dimensions provide minimum clearance. Contact surface must be
solid and level.
F. MINIMUM
MODEL
CUTOUT WIDTH
36" 36 1/4" (92.1cm)
NOTES:
1. Do not seal the range to the side cabinets.
2. Clearance from adjacent walls or other vertical surfaces or structures such as cabinets.
3. Measurements listed are minimum clearance between the cooktop and the bottom of the cabinet.
4. 0" clearance between range and cabinets or vertical surfaces that are below the cooktop height.
5. 0" clearance between range back and rear wall or cabinet.
I
H
F
G
Figure 2: Cabinet Dimensions
G. HEIGHT OF
COUNTERTOP
36" (91.4cm) Standard
35 3/4" (90.8cm) Min.
J
I. CLEARNACE
H. CLEARANCE
FROM COOKTOP
FROM SIDE
AND CABINET
WALLS
2
BOTTOM
5" (12.7cm) Min. 36" (91.4cm) Min.
6
13" Max.
(33 cm Max.)
18" Min.
(45.7 cm Min.)
24" Min.
(61 cm Min.)
24½" max.
(62.2 cm Max.)
J. CLEARANCE
WIDTH OF
OVERHEAD
CABINETS
3
36" (91.4cm) Min.