Using The Blender Jug; Markings Inside The Blender Jug; Using And Removing The Blade Assembly - Silvercrest SKMK 1200 A1 Instrucciones De Servicio

10. Using the blender
jug
NOTE: these user instructions describe the
basic functions such as mixing, chopping
and steaming. For information on the prepa-
ration of special dishes, refer to the recipe
book included in the delivery.
10.1 Markings inside the
blender jug
On the inside, the blender jug 5 is provided
with markings regarding the filling volume:
- Bottom marking: approx. 0.5 litres
- Marking I: approx. 1 litre
- Centre marking: approx. 1.5 litres
- Marking II: approx. 2 litres
- Top marking MAX: approx. 2.2 litres
corresponding to the maximum admissi-
ble filling volume
CAUTION:
When mixing liquids at speed 10 or
with button TURBO 18, the blender
jug 5 must not contain more than 1 litre,
since otherwise liquid may be ejected.
For speed settings of less than 10, the
blender jug 5 may only be filled up to a
maximum of 2.2 litres.
50 GB
NOTE:
• For some applications, the blender
jug 5 should not contain an insufficient
amount of liquid, so that the device can
function properly. Thus, for whipping
cream, for instance, you should use at
least 200 ml and when beating egg
white use at least two eggs.
10.2 Using and removing the
blade assembly
The blade assembly 27 is used to chop
food.
The blender jug 5 must never be used with-
out the blade assembly 27, since the blade
assembly 27 seals the blender jug 5 on the
bottom.
DANGER! Risk of injury from
cutting!
Please remember that the blades of the
blade assembly 27 are very sharp.
Never touch the blades with your bare
hands, to avoid cuts.
In order to remove the blade assembly 27,
proceed as follows:
1. Position the blender jug 5 horizontally.
34