Manually Terminating The Reconditioning Process; Removing A Radio Or Battery From The Charger; Troubleshooting - Motorola IMPRES WPLN4111 Manual Del Usario

At the completion of the recondition cycle, the charger automatically
recharges the battery.

Manually Terminating the Reconditioning Process

At any time during the reconditioning process of a Motorola IMPRES
battery ( STEADY YELLOW indication), reconditioning may be termi-
nated by removing and reinserting the battery within 5 seconds. This
causes the charger to terminate the reconditioning process and begin
the charging process. The charger indicator changes to a STEADY
RED .

Removing a Radio or Battery from the Charger

Use two hands to remove a radio or battery from the charger pocket –
one hand to hold and support the charger, and the other hand to
remove the radio or battery.

TROUBLESHOOTING

The IMPRES Adaptive Charger incorporates the features of:
• a universal input (100 V ac-240 V ac, 50/60 Hz) power supply
• a constant current rapid charger,
• an interrupted current (negative pulse) conditioning charger
• a reconditioning unit.
The combination of the features listed above are unique in a desktop
charger. Therefore, operation of the radio with a battery attached while
in the charger is not recommended.
While in the charger, radio operation may result in minimally reduced
radio performance and extended battery charge time.
Additionally, the conditioning charge feature of this system creates an
audible "ticking" sound in the receiving radio during the rapid and
trickle charge modes of operation. This sound is caused by periodic
discharge pulses to the battery. Should this sound be objectionable to
the user, changing the switch position located on the bottom of the
12