General Safety Rules - SCOPREGA Bravo BST 300 Manual De Instrucciones

ELECTRIC INFLATOR
BST 300 - BST 800 - BST 800 BATTERY
Catalogue number
BST 300 6130131 BST 800
SAVE THIS INSTRUCTION MANUAL FOR REFERENCE
WARNING!
Please read these instructions carefully before using the inflator. Failure to follow instructions
could cause damage to the product and serious harm to persons.
WARNINGS:
1. Read these instructions.
2. Keep these instructions.
3. Follow all instructions.
4. Do not block any ventilation openings. Install in accordance with the manufacturer's
instructions.
5. Protect the cord from being walked on or damaged.
6. Do not open the inflator. Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way.
7. Do not disassemble product. Incorrect reassembly may result in a risk of Short Circuit.
8. Provide adequate ventilation and refrain from placing items on or around the product during
operation.
9. Keep this product out of the reach of children.
BST 800
6130132 6130134
BATTERY
Instructions manual
10. Since the vibrations produced by the inflator may cause it to "walk", do not operate it on a
high shelf and keep movements under control.
DO NOT SUPPLY THE INFLATOR AT HIGHER VOLTAGE THAN NORMAL

GENERAL SAFETY RULES

1. CONSIDER WORK AREA ENVIRONMENT. Don't expose the inflator to rain. Don't use it in presence
of flammable liquids or gases.
2. AVOID UNINTENTIONAL STARTING. Don't start the inflator with the inlet port in contact with dust
or water.
3. STAY ALERT. Watch what you are doing. Use common sense.
4. CHECK DAMAGED PARTS. Before further use of the inflator, a guard or other part that is damaged
should be carefully checked to determine that it will operate properly and perform its intended
function.
5. DO NOT OPERATE portable inflators near flammable liquids or in gaseous or explosive
atmospheres. Motors in these inflators normally spark, and the sparks might ignite fumes.
6. WARNING! RISK TO BREATHING. The compressed air from your inflator is not safe for breathing.
Never inhale air from your inflator or from a breathing device connected to the inflator.
7. WARNING! RISK OF BURSTING. Inflate items only to their manufacturer's recommendations.
Exceeding the pressure rating could cause them to explode resulting in personal injury.
8. DO NOT LEAVE THE UNIT RUNNING UNATTENDED. Overinflation could result in serious injury
and property damage.
9. WARNING! RISK OF UNSAFE OPERATION. Do not modify or attempt to repair. Never drill into
or make any modifications to the inflator or its attachments.
10. Never carry the inflator by the hose.
USE OF THE BST
BST 300, BST 800 and BST 800 BATTERY are easy to use two-stage inflators. BST 800 BATTERY
is equipped with a built-in rechargeable battery. The first turbine stage provides a lot of air at low
pressure (about 50 mbar; 0.8 psi). When the turbine reaches the maximum pressure, it is switched
off by powering the pressure module with two pistons. In this case, there will be less volume of air,
but much more pressure.
This step is perceptible by the fact that the second module (with pistons) is noisier. When refilling,
the turbine module, being the pressure higher than 50 mbar (0.8 psi), starts immediately, then
switches off and enables the module with pistons.