Trevi XF 3800 PRO Guía Rápida página 12

ENGLISH
Set the main switch POWER ON/OFF (18) to "0" to completely switch off the device or charge the battery.
Move the main POWER ON/OFF switch (18) to "II" to turn on and use the device with 30V
STAND-BY
You can switch the system to standby mode using the button
- In this mode, if the unit is connected by 220V mains cable, the battery will be recharged.
- If the main switch POWER ON/OFF (18) is in position "II" and the machine is then connected by 220V mains cable, the Stand-by
mode the appliance switches on again only by pressing the same button
control (the main switch POWER ON/OFF(18) the device will turn on only by turning the main switch (18) to "I").
Caution:
- The Stand-by function works only when the main POWER ON/OFF switch (18) is in position "I" or "II".
- In stand-by function there is no LED indicating.
- We remember leaving the unit in stand-by function the battery discharges faster than using the POWER ON/OFF switch(18).
MODE SETTING FUNCTION
To change the mode function, press more 'times the MODE key (11) on the unit or press the button (31) on the remote control
to select RADIO (display will show the frequency), BLUETOOTH (the display BLUE), USB/SD (only if the USB/SD socket(16) is
connected to a memory, the display shows for a few seconds "USB" or "SD"), AUX (the display shows LINE).
ADJUSTING THE VOLUME
1. Turn the Main Volume control (14) to increase or decrease the overall volume of playback, or use the buttons (29) and (33) on
the remote control.
2. Turn the MIC VOL(1) to adjust the volume level signal inputs MIC 1/2(3). The adjustment acts on the two inputs simultaneously.
PRE-EQUALIZER
This unit has a pre audio equalization system set. Press the EQ button (4) on the unit or the (32) button on the remote control to
select one of five available audio equalizers, and that best suits the sound playback.
SETTING TONE TREBLE AND BASS
Acting on the TREBLE slider(10) to adjust the treble.
Acting on the BASS slider(9) to adjust the bass.
ECHO EFFECT
Acting on the ECHO slider(7) to increase or decrease the echo effect on the inputs MIC1 and MIC2.
Note: the echo only works on microphone inputs.
MIC EQ
Act on the MIC EQ slider(8) to adjust the bass/treble on MIC1 and MIC2 inputs.
Note: The EQ effect acts solely on microphone inputs.
DISCO-LIGHT EFFECTS
To activate the effects Disco Light press the LED button(6).
To cancel the effect Disco-Light, press the LED button(6).
VOICE GUIDE
To activate the voice guide (only in English), press and hold for a few seconds the
control, the display will show "ON" for 1 sec.
To turn off the voice guide, press and hold for a few seconds the
display will show "OFF" for 1 sec.
FM RADIO FUNCTION
AUTO MEMORY
1. Connect the Aux-In cable to the socket(17) for use as a radio antenna.
2. Turn on the unit and press repeatedly the MODE key(11) on unit, or the button(31) on remote control and select RADIO function
(the display will show the frequency).
(
2) on unit or button (22) on the remote;
(2 ) on the unit or the button
(6)

(6) button on unit or button(26) on remote control, the

12
XF 3800 PRO
50Hz power cable.
(2) the remote
button on unit or button(26) on remote