Grilling Guide - Kenmore 415.23667310 Manual De Uso Y Cuidado

GRILLING GUIDE – Getting Started
First Time Use
Read your Assembly Manual and ensure the grill is put
together properly. Remove all Point-of-Purchase advertising
material from all grill surfaces before first use. We
recommend operating your grill on its highest setting for 15-
20 minutes prior to your first use. This aids in removing the
oils used during manufacturing.
Lava Rock / Briquettes
This gas grill has been designed, engineered, and tested to
be used with flame tamers or heat diffuser plates to provide
more even heating, improve the cleaning process, and
reduce flare-ups. The addition of after market lava rocks,
charcoal, or briquettes of any type will cause poor
combustion and increase the likelihood of a grease fire, and
is not recommended. Using briquettes, lava rock, or
charcoal in this grill will void your warranty. For extra
smoke flavor, we recommend using a smoker box with wood
chips.
4 • 464323113
Temperature - Convective Grills ONLY.
The temperature gauge in the hood of your new grill
measures air temperature. The air temperature inside your
grill will never be as hot as the temperature at the cooking
surface.
Note: Since 1995, all regulators (the part that attaches to
the gas tank to regulate the flow of gas) have included a
safety feature that restricts gas flow in the event of a gas
leak. You can inadvertently activate this safety feature
without having a gas leak. This typically occurs when you
turn on the gas using the grill control knob before you turn
on the LP tank valve. If the gas regulator safety feature
activates, the grill will only reach temperatures between
250°F and 300°F even with all burners on the high setting.
Regulator
If your grill is not getting hotter than 250°F to 300°F these
steps should be taken first to reset the gas regulator safety
device:
1. Open the grill lid.
2. Turn off all knobs on the control panel in front.
3. Turn off the tank knob.
4. Disconnect the regulator from the LP tank.
5. Wait 30 seconds.
6. Reconnect the regulator to the LP tank.
7. Slowly open the LP tank knob all the way. Do not put
excessive force on the valve at the full open position to
avoid damaging the valve.
8. Turn on the appropriate control knob and light the grill
per the instructions on the control panel.
An illustration of this process is included in this Use & Care
Guide. See Troubleshooting section for additional
information.
Pre-Heating Your Grill
Just like your home oven, your grill should be pre-heated to
provide optimum performance. Pre-heat the grill on high for
10-15 minutes – longer if weather conditions require. Please
refer to the lighting instructions inside the Use & Care Guide
if you have questions about how to light your grill. A
match-light chain and hole is provided for your
convenience.
Coupling Nut