Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Use and maintenance
Select the power with power selector
Turn the thermostat control until it is at the maximum position.
Once the room has reached the desired temperature, slowly move the control until
there is a soft "click" and the device is disconnected. From this time the heater
turns on and off automatically, keeping the pre-selected comfort temperature.
Anti frost device thermostat
This device is especially useful in places where low temperatures are reached and
there is a risk of water freezing in internal water pipes. The heater will
automatically maintain the temperature of the room at about +5ºC when left on this
setting.
IMPORTANT: The LED will illuminate only if the heater stops for overheating, whether
due to a malfunction of the same or that the heating is being used inappropriately.
5.
Maintenance
Before carrying out any maintenance work, make sure that the device has been
disconnected from the mains and let the heater cool down for a few minutes.
Periodically, to prevent an accumulation of dust, clean the inlet air filter (Fig.1-5). Acting
on the same tab, you can easily remove the filter. You can use a damp cloth with water
or a vacuum cleaner. Never use petrol or aggressive and /or abrasive dissolvents to
clean the device.
To clean the heater body, use a damp cloth with water and never use petrol or
aggressive and/or abrassive dissolvents to clean the device.
Do not immerse the device or spray with water.
If the appliance is not to be used for any length of time, we recommend returning it to its
original package and storing it in a dry, dust-free place.
O
Stop
Fan (cold air)
I
Hot air heater (1.000W)
II
Very hot air heater (1.800W)
Min.
.
Max.
15
Publicidad
