ROBBE POWER PEAK LIPOLY 300 EQ Manual De Uso página 7

Dear customer,
Congratulations on your decision to purchase
the POWER PEAK LIPOLY 300 EQ fast charger.
Although the battery charger is easy to
handle, it is still important that you read right
through the operating instructions, and the
safety notes at the end of the instructions,
before using the charger for the first time.
1. General description
The POWER PEAK LIPOLY 300 EQ is a reaso-
nably priced, high-quality 12 V fast charger with
integral Equalizer housed in a metal case. It is
designed for charging LiPo batteries (3.7 Volts /
cell) consisting of 1 to 4 cells. The charger auto-
matically detects the cell count and therefore
also the setting of the charge cut-off voltage.
The charge current is set by selecting the bat-
tery capacity; the available range is 300 to 3000
mAh. The recommended charge rate is 1 C
(battery capacity = charge current); see also the
section entitled "Charge process". The Status
LED and beeper indicate the progress of the
charge process as well as the termination of the
charge.
If the charger is connected to a Power Peak
SPS 5A mains power supply unit (PSU) (No.
8485), it can also be operated from the 230 V
2. Controls
Blade
fuse
12 V
connecting
lead
All manuals and user guides at all-guides.com
Operating instructions
Power Peak LIPOLY 300 EQ
Rotary adjustor for setting the charge current
mains. It then becomes a dual-power charger:
230 V AC and 12 V DC.
3. Connections
Locate the power lead attached to the side of
the charger, and connect it to a 12 V car batte-
ry or a 12 V mains PSU (red = + terminal, black
= - terminal). The unit is now ready for use.
The charger is protected against reverse polari-
ty, but you should still take every care to avoid
this error, as it will burn out the fuse.
If the fuse burns out, it must be replaced with an
identical type (5 A); these items are available
from any car accessory shop or filling station.
Connect the Lithium battery to the battery
sockets on the right-hand side of the case using
a charge lead fitted with banana plugs. Take
care to maintain correct polarity: red = + termi-
nal / black = - terminal.
The charger output is protected against dama-
ge caused by reverse polarity and short-circuit,
but it is still important to avoid these errors, or
to eliminate them without delay.
4. Selecting the charge current
The correct charge current must be set before
you initiate the charge process. This is accom-
plished by turning the rotary potentiometer on
1
No. 8505
Equalizer
LED`s
Voltage
sensor
socket
Battery
sockets
red = +
black = -
Start button
Status-LED