ROBBE POWER PEAK LIPOLY 300 EQ Manual De Uso página 8

the front face of the charger to the position cor-
responding to the battery's total capacity (300
... 3000 mA). This equates to a charge rate of 1
C.
1 C means: capacity value = charge current.
• Example: 1500 mAh LiPo cell: 1 C = 1500
mA (= 1.5 A) charge current.
This is the correct charge current for nearly all
Lithium battery types currently in use. Of
course, battery packs of higher capacity - max.
3000 mAh - can also be charged, but the
charge time is proportionately longer.
Certain high-current Lithium batteries can also
be charged at a rate higher than 1 C.
5. Charge process
• Locate the power wires attached to the
side of the charger, and connect them to a
12 V car battery or a 12 V mains PSU,
maintaining correct polarity (red = + termi-
nal, black = - terminal). The charger is now
ready for use.
A battery pack can be charged with the vol-
tage sensor lead connected (recommen-
ded) or without.
• Connect the Lithium-Polymer battery to the
charger by plugging the voltage sensor
lead into the appropriate socket.
• Take care to maintain correct polarity: the
black wire must be aligned with the arrow
marking on the charger case.
• Now locate the main power wires attached
to the battery and connect them to the
charge sockets, again maintaining correct
polarity (red = + / black = -).
• Holding the Start button pressed in initiates
the charge process. Pressing it again at any
time interrupts the process.
At a charge rate of 1 C the charge process
for a discharged battery lasts about 90
minutes.
The Lithium battery is charged at a con-
stant current until the pack reaches the final
charge voltage of around 4.2 V per cell (B).
All manuals and user guides at all-guides.com
Operating instructions
Power Peak LIPOLY 300 EQ
5.1 Key to the flashing sequences
Charge mode
6. Equalizing
1. Locate the voltage sensor lead attached to
2. Take care to maintain correct polarity when
3. Now connect the main power wires atta-
4. Press the Start button briefly.
5. You can interrupt the Equalizing process at
2
After this point the voltage is held at a con-
stant level, and the residual charge takes
the form of a declining current curve (C),
until the process is terminated at the cut-off
point (D). Charge current = C/10.
A
Battery status
1 No charge process
Charge process
2
started
Charge current above
3
¼ C
Charge current below
4
¼ Cor above 1/10 C
5 Battery charged
the Lithium battery and connect it to the
charger's voltage sensor socket.
connecting the voltage sensor lead: the
black wire must be aligned with the arrow
marking on the charger case.
ched to the battery to the charge sockets,
again maintaining correct polarity (red = + /
black = -).
any time by pressing the Start button
again.
No. 8505
B C D
Status LED indicator
LED flashes green at
0.5 second intervals
LED glows green con-
stantly
LED flashes green
LED flashes orange
LED flashes orange,
beeper sounds