Voltage Check List - Gallagher PowerPlus B100 Instrucciones

VOLTAGE CHECK LIST

Yes
Turn energizer off and
remove the fence wire from
the red (FENCE) terminal.
Turn energizer on again and
check using a DVM3 Digital
Voltmeter (G503). Is the
voltage across the terminals
greater than 5000 volts?
Yes
Reconnect fence
wire and turn the
energizer on. Test
the earth system
using the DVM3.
Is the earth voltage
more than
200 volts?
Yes
Improve the earth
system: add
galvanised earth
stakes to the earth
system until the
earth voltage is
200 volts or below.
12
Is the energizer operating?
No
1. Check the electrical connections
are secure eg. from the fence to
the red (FENCE) terminal, from the
earth system to the green (EARTH)
terminal, at gates etc.
2. Check the voltage on the fence
every 33m (100ft). Note if the
voltage is dropping. The closer to a
fault, the lower the voltage reading
will be.
Become aware of things that cause
faults and always be on the lookout
for: stray pieces of wire on the
fence, heavy undergrowth, cracked
or broken insulators, broken wires
etc.
Gallagher 3E1922 PowerPlus User Manual
No
Have the battery tested.
If the battery is OK(12V
battery - at least 11.5V,
9V battery - at least 6V)
then the energizer needs
No to be serviced.