U.S.Robotics 8000 Guia De Instalacion página 3

Power LEDs: The orange-yellow Power LED flashes once per second to indicate the
system is functioning properly.
Status LED: This LED should only be lighted if the broadband router is connected.
WAN LED: The green WAN port LED flashes when the WAN port is sending or receiving
data.
LAN Port LED: This green LED is always lighted when each specific LAN port is in use.
Uplink Port: The Uplink port is used to attach any additional hubs to the broadband router
in order to expand the Local Area Network (LAN).
LAN Ports 1-4: The LAN ports are used to connect devices to the local area network. The
green Link/Act LEDs flash when the specific LAN port is sending or receiving data. The
green 10/100 LEDs are lighted to indicate a speed of 100 Mbps and unlighted to indicate a
speed of 10 Mbps.
Note: When an Ethernet cable is connected to the Uplink port, only LAN ports 2, 3, and 4
can be used to connect PCs to the local area network.
PRINTER: This parallel port is used to attach a printer to the local area network.
WAN: The RJ-45 WAN port is used to connect to a broadband modem or to an Ethernet
broadband router.
COM: This serial port can be used to connect an analogue modem.
5VDC: This connection port is for the power supply of the broadband router.
3