U.S.Robotics 8000 Guia De Instalacion página 4

Installation
Broadband Modem
Step 1.
Turn off your PC or Macintosh and unplug the power cord.
Step 2.
Connect one end of an Ethernet cable to your PC's Ethernet
adapter. Connect the other end to one of the LAN ports on the
broadband router.
Step 3.
Connect one end of an Ethernet cable to the WAN port on the
broadband router. Connect the other end to the LAN port on your
modem.
Step 4.
Connect the power cord to the power adapter. Connect the
power adapter to the power jack on the broadband router. Plug the
power cord into a standard power outlet. The broadband router will
automatically enter the self-test phase. When it is in this phase, the
Power LED will light up for approximately five seconds, then flash three
times to indicate that the self-test operation is complete. Finally, the
Power LED will continuously flash once per second to indicate that this
product is operating normally.
Step 5.
Plug in the power cord for your PC or Macintosh and turn your
computer on.
Step 6.
If you want to share a printer across the network, connect the
cable from the printer to the PRINTER port on the rear of the broadband
router. Refer to section IV of the manual on the CD for instructions on
enabling the print server.
Note: After you have installed your broadband router, it is recommended
that you change the administrator password for your network. Open a
Web browser and type http://192.168.123.254 to access the
Configuration Utility. The default administrator password for your network
is admin. Log in and click Toolbox. Enter the old password and then
enter and confirm the new password. If you forget your password, refer
to the Console Mode section of the user guide on the CD.
Note: It is recommended that you write down the settings for your
broadband router for future reference. You can view the settings in the
Configuration Utility.
4