U.S.Robotics 8000 Guia De Instalacion página 5

Analogue Modem
You can manually change the WAN type to use an analogue modem
instead of a broadband connection. Perform the following steps to
configure the broadband router for an analogue modem:
1. Detach the Ethernet cable from the broadband router. Connect the
modem cable to your analogue modem and to the COM port on the
broadband router. Make sure the modem is powered on.
2. Go to the Configuration Utility and click Primary Setup. Click Change
and select the WAN type as Dialup Network. Enter the appropriate
information for your dial-up Internet service.
3. Click Save and reboot the broadband router. Click Dial-up to initiate
a dial-up session with your ISP. The peripheral status will display
whether or not the call was successful. If the settings are correct, the
analogue modem can be used to connect to the Internet. If the
settings are not correct, you must enter in the correct values before
the modem can be used to connect to the Internet.
Note: After you have installed your broadband router, it is recommended
that you change the administrator password for your network. Open a
Web browser and type http://192.168.123.254 to access the
Configuration Utility. The default administrator password for your network
is admin. Log in and click Toolbox. Enter the old password and then
enter and confirm the new password. If you forget your password, refer
to the Console Mode section of the user guide on the CD.
Troubleshooting
I can't connect to the broadband router.
Possible Solution:
Make sure the broadband broadband router is properly installed, the LAN
connections are okay, and the power cord is plugged in.
Possible Solution:
Make sure that your PC and the broadband router are on the same
network. Initiate the DHCP function and retrieve the IP address
automatically.
5