Declaración De Conformidad Con Fcc - U.S.Robotics 8000 Guia De Instalacion

6. Escriba Ping seguido de su dirección de servidor DNS conocida. De
este modo podrá descomponer nombres válidos de hosts de Internet
en direcciones IP y comprobar si puede acceder a Internet.
Para obtener más información sobre el broadband router, consulte la
sección "Preguntas más frecuentes" del CD-ROM de instalación.
¿Sigue teniendo problemas?
Llame al departamento de Asistencia técnica de U.S. Robotics
Los especialistas del servicio de asistencia técnica también podrán
responder a cuestiones técnicas sobre los productos de U.S. Robotics.
En España:
902-117-964
8:00 h - 19:00 h CST (hora central estándar de EE.UU.), de lunes a
viernes.
Para obtener información de contacto actual para recibir asistencia,
diríjase al siguiente sitio Web:
http://www.usr-emea.com
Llame al distribuidor que le vendió este producto de U.S. Robotics
Puede que su distribuidor pueda solucionar el problema por teléfono o
puede que le pida que le traiga el producto a la tienda para revisarlo.
Declaración de conformidad con FCC
Declaramos bajo nuestra exclusiva responsabilidad que el U.S. Robotics Broadband Router al que se refiere esta
declaración es conforme a las siguientes normas u otros documentos normativos:
• ANSI C63.4-1992 Methods of measurement
• Federal Communications Commission 47 CFR Part 15, subpart B
15.107 (e) Class B Conducted Limits
15.109 (g) Class B Radiated Emissions Limits
FCC Class B Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. this device may not cause harmful electromagnetic interference, and
2. this device must accept any interference received including interference that may cause undesired operations.
Radio and Television Interference
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates and uses radio frequency energy and, if not installed and used in accordance with
the instructions, may cause interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna or cable input device.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The user may find the following information prepared by the Federal Communications Commission helpful: The CIB
Interference Handbook and The CIB Telephone Interference Bulletin.
These documents are available on the Internet through the FCC Compliance and Interference Bureau Home Page at
http://www.fcc.gov/cib listed under documents. Select CIB Interference Handbook or CIB Telephone Interference
Bulletin.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's
50