Installation Declaration - Leister LE MINI 400 Instrucciones De Funcionamiento

Installation declaration

(As defined by the EC Machinery Directive 2006/42; Annex II B)
Leister Technologies AG, Galileo-Strasse 10, CH-6056 Kaegiswil/Switzerland hereby declares that the
incomplete machine
Designation:
Type:
– insofar as is possible from the scope of supply – corresponds to the applicable fundamental requirements of the
EC Machinery Directive (2006/42).
The incomplete machine furthermore corresponds to the requirements of the following EC directive(s):
EC directive(s):
Harmonised standards:
We furthermore declare that the special technical documents pursuant to Annex VII (Part B) have been compiled
for this incomplete machine and that we are committed to communicate these electronically to the market
surveillance authorities upon justified request.
Name of the documentation officer: Patrick Rieder, Compliance Manager
The commissioning of the incomplete machine is prohibited until it may be determined that the machine in which
the incomplete machine has been installed corresponds to the provisions of the EC Machinery Directive (2006/42).
Kaegiswil, 28.11.2011
Disposal
Power tools, accessories and packaging should be recycled. For EU countries only: do not dispose of
power tools in your household rubbish! According to the European Directive 2002/96 on waste electrical
and electronic equipment and its implementation in national law, power tools which can no longer be
used must be collected separately and recycled.
12
Air heater
LE MINI; LE MINI SENSOR
Electromagnetic Compatibility it 2004/108
Low Voltage Directive 2006/95
EN 12100-1, EN 12100-2, EN 60204-1, EN 14121-1,
EN 55014-1, EN 55014-2,
EN 61000-3-2, EN 61000-3-3,
EN 50366, EN 62233, EN 60335-2-45
Bruno von Wyl, CTO Beat Mettler, COO