Legs/Feet - CASO DESIGN WineDuett Touch 12 Instrucciones De Funcionamiento Originales

 Locate the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.
 Ambient temperature below 10°C or above 32°C will hinder the performance of the
appliance.
 This unit is not designed for use in a garage or any other outside installation.
 Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
 The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 10-15 cm around the appliance.
 Do not cover up any openings on the device and do not block these off.
 The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
 For energy saving reasons please ensure that the door is closed when the appliance is
turned on.
13.5.2

Legs/feet

There are 3 large feet pre-installed and one small foot which is not
installed.
This small foot should be screwed into the hole in the hinge of the door.
By screwing or unscrewing this foot you can adjust the wine cooler to
have a level stand.
caso Wine Duett
Small Foot can be found in the box.
30