Legs/Feet; The Handle Installing - CASO DESIGN WineChef Pro 126 Manual Del Usuario

 Locate the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.
 Ambient temperature below 16°C or above 38°C will hinder the performance of the
appliance.
 This unit is not designed for use in a garage or any other outside installation.
 Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
 Do not cover up any openings on the device and do not block these off.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they guarantee
the prerequisites for the safe use of this device.
 For energy saving reasons please ensure that the door is closed when the appliance is
turned on.
12.5.2

Legs/feet

There are FOOT (3 bigger feet and 1 small foot).
To level your appliance, adjust the front legs at the bottom of the appliance.
12.5.3

The handle installing

The wine cooler comes with one metal stainless steel handle. To install simply screw them to
the door with the supplied screws.
To do this, slide the rubber seal on the back of the
door to the side to lay open the predrilled holes.
Use the included screws to install the handle on
the door.
Then reinsert the rubber seal in the correct
position.
31