Making Coffee - T-Fal KM740 Guia Del Usuario

TF_COFFEEMAKER_KM740_NC00115301_NAFTA_EXE 12/09/12 11:26 Page6
Note: The amount
of brewed coffee
will be less than the
water placed in the
coffeemaker since
about 10% is
absorbed by the
coffee grounds and
the filter.
CAUTION: To avoid overflowing the filter holder, the carafe must
fit securely into the coffeemaker with the lid on. If not properly positioned
on the heating plate, it could cause hot water or hot coffee to overflow.
6
1- Place the coffee maker on a hard, flat surface.
With the coffeemaker turned off, plug the
machine into a 120V outlet.
2- Fill the carafe with fresh, cold water
(preferably bottled or filtered water). Open
the hinged cover and pour the water into the
water tank. The number of cups is shown by
the water level indicator. Do not exceed the
(Fig. 1, 2 and 3)
maximum level
3- Place the carafe with its lid on to the heating
plate (h) making sure it is secure on the
heating plate to activate the pouring
mechanism.
4- Open the coffee maker lid (b), insert the filter
holder (i) by using the two handles on either
side. Make sure it is securely pushed down
and locked into place. Then insert a standard
#4 cone paper filter or the permanent filter
(j) into the filter holder (i). Use a fresh paper
filter or clean the permanent filter for each
(Fig. 4 and 5)
carafe of coffee
5- Add about 2 ounces of ground coffee for 12
cups. Experiment with the amount of coffee
used in order to adjust the flavor to your
taste. Do not exceed the maximum level
(Fig. 6)
.
6- Close the top lid making sure it is securely
(Fig. 7)
closed .
7. Press the On/Off button (k). The button will
illuminate, indicating that your coffee maker
has begun the brewing cycle.

5. Making coffee

.
.