Graco Angelcare Manual Del Propietário página 17

Movement & Tic.
The Movement Sensor is enabled and detects your baby's movements. You will also hear
a ticking sound from the Nursery Unit as the Sensor Pad senses your baby's movement.
Your baby's sounds, the movement alarm, and the ticking will not be transmitted to the
Parents' Unit. For this setting, the Movement and "Tic" symbols will appear (see fig. 8).
Once you have completed your selections, press the Menu button to change another
feature setting or press the Exit button to end programming.
Out-of-Range Indicator
The Out-of-Range Indicator will alert you when the Parents' Unit and the Nursery Unit are
not in communication with each other. This may occur when the units are too far from
each other, if the Parents' Unit is on when the Nursery Unit is off, or if the units have lost
communication with each other. The Out-of-Range symbol will flash on the Parents' Unit
and you will hear two beeps every eight seconds.
To turn this feature on or off:
1. Press the Menu button until the Out-of-Range symbol appears.
OF
2. " " or " " will appear below. Use the Arrow buttons to make your selection.
3. Press the Select button.
4. Press the Menu button to change another feature setting or press the Exit
button to end programming.
Voice Activation
(See fig. 10)
Voice Activation eliminates the background "hum" associated with sound monitors when
there is no significant sound being transmitted from your baby's room. It does this by
automatically placing both the Nursery Unit and Parents' Unit in a "standby" mode. When
sound is detected,the Voice Activation automatically returns both units to an active mode
and immediately transmits the alarm or your baby's sounds to you.
To use this feature:
1. Press the Menu button until the Voice Activation symbol appears.
2. " " or " " will appear. Use the Arrow buttons t o make your selection. OF
3. Press the Select button.
4. If you choose to turn Voice Activation on, press the Menu button and then use the
Arrow buttons to choose the level of sensitivity. If you want to hear the slightest sound
in the nursery, adjust the sensitivity to the maximum level (4). If you only want to hear
when the baby cries loudly, adjust the sensitivity to lowest level (1). You may have
to adjust the sensitivity level a couple of times until you get the exact level you want.
NOTE: The movement alarm will be picked up at all levels of sensitivity.
5. Press the Select button when the desired level is displayed.
6. Press the Menu button to change another feature setting or press the Exit button to
end programming.
(See fig. 9)
17
fig. 8
fig. 9
fig. 10