Graco Angelcare Manual Del Propietário página 18

Sound and Vibration Alarms
If no movement is detected by the Sensor Pad, you have the option to have a sound
alarm, a vibration alarm, or both.
1. Press the Menu button until the Sound and/or Vibration symbols appear.
2. Use the Arrow buttons to make your selection. If you want only a sound alarm, the
Sound symbol will appear. If you want only a vibration alarm, the Vibration symbol will
appear. If you want both alarms, both the Sound and Vibration symbols will appear.
3. Press the Select button when your desired setting appears.
4. Press the Menu button for the next option or press the Exit button to end programming.
NOTE: The vibration alarm will not work when the battery level is low on the Parents' Unit.
You will know when the battery level is low because the Low Battery Indicator will appear
and the unit will beep. The vibration alarm also will not work when the Parents' Unit is in
the Charging Base.
Room Temperature Control
The temperature of your baby's room is always displayed on the Parents' Unit. The Room Temperature Control,
however, is an optional feature. When you activate this feature you can set your desired temperature range for
your baby's room. If the temperature goes above or below the range you have set, the High or Low Temperature
symbol will flash and three beeps will be heard every four seconds.
If the Temperature Control alarm does go off, you can temporarily turn it off for two minutes by pressing the Power
button. The symbol will continue to flash but the beeping will stop. The alarm will begin again after two minutes
unless the room temperature returns to your preset range or you turn the Temperature Control feature off. The
preset Temperature Control range is 59º-86ºF.
To set the temperature range:
1. Press the Menu button until the High Temperature and Low Temperature symbols appear.
2. " " or " " will appear. Use the Arrow buttons to turn it on. OF
3. Press the Select button.
4. Press the Menu button.
5. The Low Temperature symbol will flash. Using the Arrow buttons, select the lowest
temperature you want the nursery to reach.
6. Press the Select button.
7. Press the Menu button.
8. The High Temperature symbol will flash. Using the Arrow buttons, select the highest
temperature you want the nursery to reach.
9. Press the Select button.
10. Press the Menu button to change another feature setting or press the Exit button to end
programming.
If you choose to turn the Room Temperature Control off, the nursery temperature will still be displayed on the
Parents' Unit; however, it will not alert you if the temperature is outside your desired range.
(See fig. 11)
(See fig. 12)
18
fig. 11
fig. 12