Graco Angelcare Manual Del Propietário página 19

Testing Your Monitor
X
MENU
CH
SELECT
EXIT
MENU
CH
SELECT
Testing for Movement.
2.
Be sure the Movement symbol
green Movement Indicator Light on the Nursery Unit will flash and the Movement symbol
Unit will swing as the Sensor Pad senses movement. Remove your hand from the mattress. The Movement
Indicator Light will stop flashing, the Movement /Tic symbol
sound after 15 seconds. Five seconds later (for a total of 20 seconds), the Nursery Unit symbol
appear on the Parents' Unit display and the alarm will beep and/or vibrate continuously on both units.
Note: After each start up, the monitor needs up to 1 minute before the movement function is ready to be
used.
To turn off the alarm on the Parents' Unit, press the Power button
Unit for two minutes. The Nursery Unit alarm, however, will continue to sound. To turn off the alarm on the
Nursery Unit, turn the unit off and then back on or pat your hand lightly on the mattress so the Sensor Pad
will redetect movement. The units will then revert to their normal functions. If the Nursery Unit alarm is not
turned off, the Parents' Unit alarm will reactivate after two minutes. NOTE: If you turn off the Nursery Unit
and leave the Parents' Unit on, the Out-of-Range Indicator
If the alarm does not sound when you are not touching the mattress, the Sensor Pad may be detecting a
continuous vibration from another source from inside and/or outside your baby's room. Common sources of
this interference are crib mobiles, fans, washing machines, or even loud music. Therefore, it is very important
to make sure all vibration sources are eliminated before using the monitor. Make sure the Sensor Pad is on a
flat, firm surface. Place the crib near a solid supporting wall and away from strong air currents. Do not use
crib mobiles or accessories that may cause vibrations. Avoid contact with the crib when the monitor is in use.
If you find the alarm will still not sound when you are not touching the mattress or crib and you have
removed all external sources of vibration, the sensitivity level may need to be decreased. Please refer to the
Movement Sensitivity Adjustment section on Pg. 13 and Pg. 21.
Testing for Battery Power.
3.
To verify that all units are operating on battery power, install batteries into the units. The Parents' Units
should operate when they are removed from the Charging Bases (after the initial 15-hour charge) and the
LCDs should be lit. The Nursery Unit should operate when the AC adapter is unplugged and the green
Power Indicator
X
EXIT
appears on the Parents' Unit. Gently pat your hand on the mattress. The
should light up.
Always test your monitor before using it the first time and then on a
periodic basis. Before testing your monitor, complete the setup
process as described above.
Testing for Sound.
1.
Turn the Nursery Unit and Parents' Unit on and be sure the Sound
symbol appears on the Parents' Unit. Have someone else speak
into the Nursery Unit or place a radio near the Nursery Unit while
you take the Parents' Unit into another room. You should hear the
sounds being transmitted from the Nursery Unit. If there is no
sound, adjust your volume control using the Arrow buttons and/or
refer to the Troubleshooting section on Pg. 23. If you experience
interference or static, switch to another channel on the Parents'
Unit.
Press the Channel/Select button for two seconds.
The Out-of-Range symbol will flash and the current channel
will be displayed. Use the Arrow buttons to choose a different
channel. When the desired channel is displayed, press the Select
button again. The Nursery Unit will automatically switch to the
same channel as the Parents' Unit. The other Parents' Unit will also
automatically switch to the same channel.
will stop swinging, and a pre-alarm beep will
will flash and sound if this feature is turned on.
19
. This will temporarily mute the Parents'
on the Parents'
will