Graco Angelcare Manual Del Propietário página 22

Temporary Mute
If you want to temporarily mute the sound on the Parents' Unit, press the Power button once. The Sound symbol
will flash continuously and the sound will automatically reactivate after two minutes. To reactivate the sound before
the two minutes are up, press the Power button again. Be sure to only press the button down for one second, as
pressing it for three seconds will turn the Parents' Unit off.
Parents' Unit Locator
If you need to locate or page the Parents' Unit, press the Page button located on the top of the Nursery Unit. The
Nursery Unit symbol will flash and the Parents' Unit will continuously beep for one minute. To stop the beep
before the minute is up, press the Power button on the Parents' Unit for one second.
Nursery Nightlight
The Nursery Unit features a soothing nightlight. Use the switch on the right to turn it on and off.
Parents' Unit and Nursery Unit Connection
There may be times when the Parents' Unit and Nursery Unit lose connection with each other. However,
if connection is lost, the Movement Sensor Pad will continue to monitor your baby and the alarm will sound in the
nursery. To reestablish the connection between the units, press the Menu button on the Parents' Unit for two
seconds. The Out-of-Range symbol will flash and a beep will sound. Then press the Page button on the top of
the Nursery Unit for two seconds. The green Movement Indicator Light will flash once, a beep will sound, and the
units will automatically reconnect. When the connection is complete, the Out-of-Range symbol will stop flashing
and the Parents' Unit will beep once.
TECHNICAL SPECIFICATIONS
No. of Channels: 8
Power Supply: Four AAA (LR03) alkaline or rechargeable batteries, or 7.5V AC adapter for Nursery Unit. Four
AAA (LR03) rechargeable batteries for each Parents' Unit and 7.5V AC adapter for Charging Base for each
Parents' Unit. Frequency: 900 MHz for sound. 2.4 GHz for data.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance may void the user's
authority to operate the equipment.
22