Installing The Cooltouch™ Control System Wall Plate - Kichler Kimberley Manual De Instrucciones

INSTALLING THE COOLTOUCH™ CONTROL SYSTEM WALL PLATE
Select a location to install your CoolTouch™Control System Transmitter.
Outlet box
You can replace an existing wall switch or, install the transmitter on ANY flat
Switch
surface.
Wall plate
Option 1: Install the control system using an existing wall switch outlet box.
Make sure the electrical power is TURNED OFF at the main panel before
continuing.
Step 1. Remove the existing wall plate and the old switch from the wall outlet
box. Wire nut the BLACK leads (hot) together and push back inside the outlet
box. (Fig. 26)
Step 2. Install the metal plate and CoolTouch™ wall plate to the existing wall
outlet box with 4 screws provided. Then place the two plastic plugs into the
Fig. 26
wall plate. (Fig. 27)
Outlet box
Metal plate
CoolTouch ™ wall plate
Option 2: Install the control system on ANY flat surface.
Screws
Select the desired location and use the CootTouch™ wall plate to mark the
Plastic plugs
location for the mounting holes. Plastic wall anchors and screws are provided
for this type of installation.
After installing the wall anchors, attached the CoolTouch™ wall plate with the
mounting screws and then insert the plastic plugs to finish the installation.
Screws
Fig. 27
23
Kimberley |
™