Installing The "Cooltouch" Control System Wall Plate - Kichler 52 Tide Manual De Instrucciones

INSTALLING THE COOLTOUCH
CAUTION: MAKE SURE THE ELECTRICITY IS TURNED OFF AT THE MAIN JUNCTION
BOX OR THE CORRECT FUSE HAS BEEN PULLED OFF AT THE MAIN JUNCTION BOX
BEFORE CONTINUING.
WARNING: All wiring must be in accordance with the National Electrical Code local
electrical codes. Electrical installation should be performed by a qualified licensed
electrician.
Select a location to install your "CoolTouch" Control System Transmitter. You can replace
an existing wall switch, or install the transmitter on ANY flat surface.
WARNING: SWITCH INSTALLATION MUST COMPLY WITH ALL LOCAL AND
NATIONAL ELECTRIC CODES.
Option 1. Install the control system using an existing wall switch outlet box.
Make sure the electrical power is TURNED OFF at the main panel before wiring.
Step 1. Remove the existing wall plate and the old switch from the wall outlet box. Wire the
BLACK leads (hot) together with connector and push back inside the outlet box. (Fig. 25)
Step 2. Install the metal plate and "CoolTouch" wall plate to the existing wall outlet box
with 4 screws provided. Then place the two plastic plugs into the wall plate. (Fig. 26)
Option 2: Install the control system on ANY flat surface:
Select the desired location and use the "CoolTouch" wall plate to make the location for the
mounting holes. Plastic wall anchors and screws are provided for this type of installation.
After installing the wall anchors, attach the "CoolTouch" wall plate with the mounting
screws and then insert the plastic plugs to finish installation.
16 | KICHLER.COM
CONTROL SYSTEM WALL PLATE
™
Outlet Box
Switch
Wall Plate
Fig. 25
Outlet Box
Metal Plate
"CoolTouch" Wall Plate
Screw
Screw
Plastic Plug
Fig. 26