Character Entry - Kenwood NX-5700 Manual De Usuario

CHARACTER ENTRY

While in the character entry screen, you can use the following two methods to enter
the characters:
Pressing the [J]/[K] keys
o
Press [J]/[K] to cycle the characters from A ~ Z, a ~ z, 0 ~ 9, and a space (default
settings).
You can also assign a character to an optional key and later press that key to recall
the assigned character: A ~ Z, a ~ z, 0 ~ 9, or a space and characters.
You can enter characters using the [J]/[K] keys when the keys function as character input
●
keys. When the keys function as line up/ down keys, it is not possible to enter a character.
Using the keypad (Optional microphone with keypad only)
o
Press the keypad keys to enter characters as shown in the table below.
You can press the [ ] key repeatedly to switch the input mode (upper case B lower
case B numbers B back to beginning).
Keypad Character Cycle (Upper Case)
1 @ # " ( ) ! $ _
2 A B C
3 D E F
4 G H I
5 J K L
6 M N O
7 P Q R S
8 T U V
9 W X Y Z
0 (space) . , ? / ' &
Character Cycle (Lower Case)
@ # " ( ) ! $ _
a b c
d e f
g h i
j k l
m n o
p q r s
t u v
w x y z
(space) . , ? / ' &
19