Kenmore 790-9418 Serie Guía De Uso Y Cuidada página 25

Removing and Replacing the Oven Door
The door is heavy. For safe, temporary storage,
lay the door flat with the inside of the door facing down.
To remove the oven door:
1. Open oven door completely, horizontal with floor (See
Figure 19).
2. Pull the door hinge locks on both left and right door hinges
down from the oven frame completely toward the oven
door (See Figure 20). A tool such as a small flat-blade
screwdriver may be required.
3. Firmly grasp both sides of oven door along the door sides.
Do not use the oven door handle (See
4. Close the door to approximately 10 degrees from the oven
door frame.
5. Lift the oven door hinge arms over the roller pins located on
each side of the oven frame (See
To Replace Oven Door:
1. Firmly grasp both sides of oven door along the door sides.
Do not use the oven door handle (See
2. Holding the oven door at the same angle as the removal
position (See Figure 21), seat the hook of the hinge arm over
the roller pins located on each side of the oven door frame
(See Figure 22). The hook of the hinge arms must be fully
seated onto the roller pins.
3. Fully open the oven door, horizontal with floor (See
Figure 19).
4. Push the door hinge locks up toward and into the oven
frame on both left and right oven door hinges to the locked
position (Figure 20).
5. Close the oven door.
Important:
Special Door Care Instructions - Most oven doors contain glass
that can break. Do not close the oven door until all the oven
racks are fully in place. Do not hit the glass with pots, pans, or
any other object. Scratching, hitting, jarring, or stressing the
glass may weaken its structure causing an increased risk of
breakage at a later time.
Figure 21).
Figure 21).
Figure 21).
Figure 19: Door hinge location
Figure 20: Door hinge locks
Figure 21: Holding door for removal
roller
pin
hinge
arm
Figure 22: Location of hinge arm and roller pin
25
Care and Cleaning
Oven door
hinge
locations
about
10°
oven
door
hinge