Remington BHT6450 Instrucciones De Seguridad página 4

ENGLISH
CHARGING
Charge the device:
• Before using for the first time.
• After it has not been used for a long time.
1. Ensure the product is switched off.
2. Connect the product to the adaptor and then to the mains.
3. Charge for 4 hours.
4. With the charger attached, the charging light will flash during charging and stay on
when fully charged.
• Run time from fully charged is up to 40 minutes.
• To preserve the life of your batteries, let them run out every 6 months then fully charge.
INSTRUCTIONS FOR USE
• Select the desired trim length prior to trimming by attaching one of the fixed combs.
• If trimming for the first time, always start with the longest length comb (12mm).
• Avoid using lotions before using your trimmer.
1. Switch your trimmer on by pressing the on/off switch.
2. Stretch the skin with your free hand so the hairs stand upright.
3. Use short linear strokes.
CHANGING ATTACHMENTS
• Always ensure the trimmer is switched off before attaching or removing a comb.
• To attach a comb, centre it over the main blade and push down until it clicks.
• To remove the comb, unclick the sides of the comb where it connects to the trimmer
and lift the comb away from the trimmer.
BODY TRIMMING
1. Place your trimmer at a slight angle, following the angle of the comb teeth.
2. Slowly slide the trimmer through the hair, in the direction of hair growth.
• Longer/thicker body hair may take more passes from different angles.
• If hair builds up in the trimmer comb during the trimming process, switch the unit off
and remove the fixed trimmer comb. Brush the trimmer/rinse comb.
• For closer more precise shaping, remove the comb.
TRIMMING WITHOUT A COMB
Your trimmer has been designed to trim any length of body hair to a length of 0.2 mm when
it is used without a comb for a 'shaven' look.
EDGING AND SHAPING OR CLOSE TRIM
1. Remove the trimmer comb attachment.
2. Hold the trimmer at a slight angle to your skin and press down gently.
4