Remington BHT2000A Instrucciones De Seguridad página 6

ENGLISH
13 Stretch the skin with your free hand so the hairs stand upright.
14 Only apply light pressure on the shaving head while shaving.
15 Shave against hair growth.
16 The Microscreen shaving technology with circular foil holes is developed to
give a controlled close cut.
, EXCHANGING THE ATTACHMENTS
17 Always ensure the trimmer is switched off before changing the trimmer
and shaver attachments.
, REMOVING THE TRIMMER COMB AND CUTTING ASSEMBLY
18 Hold the Trimmer in one hand with your thumb firmly on the Zoom wheel
to keep it from turning.
19 With your other hand, gently pull the trimmer comb attachment off the
Trimmer.
20 Remove the cutting assembly by firmly pushing up on the blade with your
thumb (Diagram E & F).
, REMOVING THE SHAVER ATTACHMENT
21 Hold the Trimmer in one hand with your thumb firmly on the Zoom wheel
to keep it from turning.
22 With your other hand, gently pull the Shaver Attachment off the Trimmer.
, REMOVING THE SHAVER COVER (Diagram G)
23 Gently push the buttons either side of the shaving foil. With the other hand
lift the shaver cover. Clean then replace.
, REPLACING THE CUTTER ASSEMBLY
24 Hold the Trimmer in one hand. With your other hand, insert the lower part
of the cutter assembly into the Trimmer, push down the cutter until firmly
attached.
, REPLACING THE TRIMMER COMB AND SHAVER ATTACHMENT
(Diagram H)
25 Hold the Trimmer in one hand with your thumb firmly on the Zoom wheel
to keep it from turning. Ensure that the Length Position Indicator is at 1.
26 Slide the comb/shaver down the grooves until it clicks into place.
, NOTE: The trimmer comb and shaver attachment can only be attached in
one way. If it does not go on correctly, turn it around and try again.
, REPLACING THE FOILS & CUTTERS
27 To ensure the continued highest quality performance from your shaver, we
recommend that the foil and cutter are replaced regularly.
6