High / Low Power Jumper; Standard Swivel Installation; Wall Mounting - Risco WatchOut Instrucciones De Instalación

High / Low power Jumper

The jumper on selector J8 needs to be on OFF (High Power
position) unless sold in countries with FCC compliance.

Standard Swivel Installation

The Outdoor detector packaging contains a standard swivel for flexible installation. Please follow
the instructions below for mounting the detector with the Standard Swivel:
1. Open Wireless WatchOUT front cover (Unlock C1, Figure 1).
2. Release internal base (Unlock I1, Figure 2).
3. Remove back tamper from the internal base (see the "Changing Back Tamper Position"
paragraph on page 7) and connect it to S5 (Figure 6, Detail A) on the Standard Swivel.
4. Select the mounting installation as follows:
Note:
Ensure that you see the engraved UP mark on the upper front face of the swivel.

Wall Mounting:

1. Insert back tamper wires through the Swivel Wires Passage (Figure 6, Detail B).
2. Secure swivel to the wall through holes S1, S3, S6 and S8.
Detail A
Standard Swivel
S1
S2
S8
S6
(see Detail C)
3. Connect the external base to the swivel using the dedicated snaps (Figure 8).
S1
S4
S5
Tamper
Figure 6
Installation Instructions
Low High
Power power
Detail B
Snaps
W1
S2
S3
Detail C
9