Connecting Electricity - Faber CYLINDRA ISOLA CYLNIS15SS600 Instrucciones De Instalación

CONNECTING ELECTRICITY

• Before moving onto the next steps, make sure the hood is properly
secured to the ceiling.
• The frame mountings must be secure to withstand the weight of the
hood and any stresses caused by the occasional side thrust applied
to the device. On completion, check that the base is stable, and will
remain stable even if side to side pressure is placed on the hood.
• In all cases where the ceiling is not strong enough at the suspension
point, the installer must provide strengthening using suitable plates
and backing pieces anchored to the structurally sound parts.
1. Remove the cover from the Field Wiring
10
Compartment with a phillips screwdriver.
2. Feed the Power Supply Cable through the electrical knockout.
3. Connect the Power Supply Cable to the range hood.
4. Attach the White lead of the power supply (A) to the White
lead of the range hood (D) with a twist-on type wire connector.
5. Attach the Black lead of the power supply to the Black lead of
the range hood (B) with
a twist-on type wire
connector (C).
6. Connect the Green (E)
(Green and Yellow)
ground wire under the
Green grounding screw.
7. Replace the field wiring
compartment cover.
Hood
wiring
21