Moen PureTouch INS115D El Manual Del Propietario página 7

3b.FOR INSTALLATION USING SMALL ROUND DECK
RING. Place round deck gasket (29) under the small
round deck ring (28). Place deck ring over hose (34)
and supply tubes (26) of faucet assembly.
4. For both installations, align the faucet assembly with
the threaded discharge tube (24) in the back. Align
tabs on faucet to holes in deck plate (27) or deck
ring (28). Place assembly down through sink while
pushing assembly toward back of sink as far as possible.
5. A groove in the treaded discharge tube (24) indicates the
minimum amount of thread lenght which must be exposed
for proper attachment of mounting nut (33) and hose.
5a. FOR INSTALLATION WHERE THE DECK IS LESS
THAN 7/8", install mounting bracket (32) (open side
up) by hooking around supply tubes, as shown, and
sliding up and onto threaded discharge tube (24).
Mounting bracket (32) can be easily installed onto
threaded discharge tube by gently pulling the
supply tubes forward away from the discharge tube,
making sure not to kink the tubing. Install and
HAND TIGHTEN medium mounting nut (33).
5b.FOR INSTALLATION WHERE THE DECK IS
GREATER THAN 7/8", turn the mounting
bracket over (open side down). Install
and HAND TIGHTEN medium mounting
nut (33). Be sure the faucet is aligned
properly with threaded discharge
tube directly in back.
6. Rotate the spout receptor (15) to the
left and right, noting where it stops. Faucet should extend to
the left and right from center equally. To readjust, untighten
medium mounting nut (33) then move spout receptor to
desired rotation. Hand tighten medium mounting nut.
Check movement of hose before final tightening of nuts. If
hose does not move freely, gently bend the supply tubes
(26) out. Do not kink supply tubes. Tighten mounting nut (33)
with the tool (36) provided. Use heavy duty screwdriver
through the holes in the bottom of the tool to tighten faucet
securely. Recheck for alignment, be sure that the faucet is
centered properly on the sink and that it does not shift
position when the spout is moved from side to side.
7. Assemble hose (34) to threaded discharge tube (24) and
tighten with adjustable wrench.
HELPLINE: 1-800-BUY-MOEN
INS115D
(3b)
SINK
(5a)
(<7/8")
(5b)
(>7/8")
SINK
(7)
6