Cleaning, Maintenance And Storage; Cleaning Instructions; Storage; Maintenance - MSA Workman FP Stryder Instrucciones Para El Usuario

4

Cleaning, Maintenance and Storage

4.1

Cleaning Instructions

Use a clean damp (not wet) cloth to remove dirt or contamination which may cause corrosion or
hamper readability of labels. Wipe off any moisture before returning the device to service. Remove any
surface contamination such as concrete, stucco, roofing material, etc., that could accelerate cutting or
abrading of attached components. The frequency of cleaning should be determined by inspection and
by severity of the environment. In highly corrosive environments cleaning should be done every two or
three days. Never use solvents to clean the device as they may damage the plastic components. Don't
use abrasives to scour the device as they may damage the surface and the labels. To remove oil or
grease, use a mild dishwater detergent on a damp cloth or sponge and follow by repeated swabbing
with a clean cloth to remove all soap residue. Never immerse the product in water or other liquid.
4.2

Storage

Store the device in a clean, dry place indoors. Store the product away from heat and steam and never
allow it to rest for lengthy periods of time on concrete or ash floors as the lime sulfur and ash can cause
corrosion.
4.3

Maintenance

User maintenance consists of cleaning and drying the device and replacement of the glide pad. All
other maintenance or repair/work must be done at the factory or by an authorized person. (Authoriza-
tion by MSA must be written).
WORKMAN FP STRYDER
US
11