Hatco HBG Serie Manual De Instalación Y Operación página 13

Power ON/OFF Switch
Adjusting the Temperature Control
Temperature Control
Power I/O (on/off) Switch
Changing the Setpoint Temperature — Digital
Temperature Controller
NOTICE
Built-in units must not have a setpoint temperature higher
than 200°F (93°C). Temperatures exceeding 200°F (93°C)
will damage unit and void warranty.
NOTE: The temperature shown on the display may be
inaccurate when unit temperature is below 130°F (54°C).
NOTE: After 10 seconds of inactivity during the programming
process, the controller will exit programming mode
automatically without saving any changes.
OPTIONS AND ACCESSORIES
Up Arrow
SET Key
Changing Fahrenheit and Celsius Setting — Digital
Temperature Controller
NOTE: After 10 seconds of inactivity during the programming
process, the controller will exit programming mode
automatically without saving any changes.
Key
Down
Arrow
Key
Display