Waste Management - GYS POWERDUCTION 10R Manual De Instrucciones

Translation of the original instructions
Connection:
• This machine must be connected to an earthed socket.
• These Class A devices are not intended to be used on a residential
site where the electric current is supplied by the public network, with
a low voltage power supply. There may be potential diffi-culties in
ensuring electromagnetic compatibility on these sites, because of the
interferences, as well as radio frequencies.
Maintenance:
• If the power cable is damaged, it must be replaced by the manufac-
turer, its after sales service or an equally qualified person to prevent
danger.
•Service should be performed by a qualified person.
• Warning! Always disconnect from the mains before performing
maintenance on the device. High Voltage and Currents inside the
machine.
• Remove the casing on a regular basis, to remove any excess dust.
Take this opportunity to have the electrical connections checked by
a qualified person, with an insulated tool.
• Do not use solvents or any agressive cleaning products.
• Clean the device's surfaces with a dry cloth.
Regulations:
• Device complies with europeans directives.
• The certificate of compliance is available on our website.
• EAC Conformity marking (Eurasian Economic Community).
• Equipment in conformity with Moroccan standards.
• The declaration C‫( م‬CMIM) of conformity is available on our web-
site (see cover page).

Waste management:

• This product should be disposed of at an appropriate recycling facil-
ity. Do not throw away in a domestic bin.
DESCRIPTION
The Powerduction 10R has been designed to heat ferrous metallic elements by induction heating. Its main purpose is the
unjamming of parts such as bolts or exhaust pipes.
Carry cas econtents:
Le Powerduction 10R is supplied in a carry case that contains t(see fig.1) :
- the generator and its inductor cable , 1 ,
- 3 coiled wired, diameter 18 mm / 24 mm / 30 mm 2 ,
- a flexible braided wire 3 ,
- a straight rigid wire 4 .
10
POWERDUCTION 10R
EN