GYS POWERDUCTION 10R Manual De Instrucciones página 9

Translation of the original instructions
• In case of burns, rinse with water abundantly and see a medical
doctor as soon as possible.
Dangerosity of the gas fumes
• Keep the head away from the fumes, do not inhale.
• If working inside, ventilate the area or use a fume extractor to evac-
uate the gases and fumes.
• Induction heating of certain materials such as adhesives and flux
can generate fumes and gases. Breathing these fumes and gases
can be dangerous for your health. For example, heating urethane
generates a gas : hydrogen cyanide, potentially mortal for hu-mans.
• If the ventilation is insufficent, use an approved respiratory unit.
• Read the safety data sheets (MSDS) and the manufacturer's ins-truc-
tions for adhesvies, flux, metals, consumables, coatings, clea-ning
agents, corrosives, and paint strippers.
• Do not use the heater on parts being degreased or sprayed.The
heat might react with fumes and generate highly toxic gases.
• Work in a confined area only if it's well ventilated, or use an ap-
proved repiratory/filtration unit. Make sure that a qualified per-son
is around to watch over you. The fumes and gases released while
heating can replace oxygen or air, causing accidents or death.
Check the quality of the air you're breathing
• Do not overheat metals, such as galvanised steel, covered with lead
or cadmium, unless the coating is removed from the surface before
it's heated, that the area is well ventilated, and if needed, use an
approved filtration/respiratory unit.. Foundry pieces and all metals
containing such elements may generates toxic fumes if overheated.
• Check the MSDS for temperature related details.
Warning, electrical danger
Caution: Danger of optical radiation when the heated metal ele-
ments reach fusion.
Warning ! Major magnetic field. People wearing active or pas-
sive implants must be informed.
No further protectective steps are required when the machine is
used on its own. Further restrictions and/or protective measures may
be necessary in other cases.
After maintenance, the magnetic field levels must be checked be-fore
the machine is used again.
When switched on, never put the inductor near the head or vital
organs.
People wearing pacemakers are advised to not come close to the
machine. Risk of disruption of pacemaker operations when close to
the machine.
Consult a doctor before getting close to induction heaters.
Risk of metal or adhesive projections
• Wear approved protective goggles with lateral protections, or
protect the whole face with a screen.
• Wear protective clothes.
• Wear gloves.
POWERDUCTION 10R
EN
9