Activating The Autohold Function (Ahold); Activating Acoustic Signals (Beep) - Seca 757 Manual De Instrucciones Y Garantía

hold
tare
send
print
Activating the Autohold
function (Ahold)
Activating acoustic
signals (BEEP)
64 •
5. To change your setting or call up another submenu,
keep pressing the arrow key until the required set-
ting is displayed (here: level "2").
6. Confirm the setting with the Enter key.
You exit the menu automatically.
7. To make further settings, call up the menu again
and proceed as described above.
NOTE
If no key is pressed for approx. 24 seconds, you
will exit the menu automatically.
If you activate the Autohold function, the measured
result for each weighing operation continues to be dis-
played after the load has been removed. This means
you no longer have to activate the Hold function manu-
ally for each individual weighing operation.
NOTE
With certain models, this function is already
activated at the factory. If required, you can
disable this function.
1. Select the "AhOLd" item from the menu.
2. Confirm the selection.
The current setting is displayed.
3. Select the setting you require:
– On
– Off
4. Confirm your selection.
You exit the menu automatically.
You can set whether an acoustic signal is to be emitted
whenever a key is pressed or a stable weight value has
been attained. The latter is relevant for the Hold/Auto-
hold function.
NOTE
The function "Acoustic signal when weighing
value is stable" is activated at the factory. If
required, you can disable this function.
1. Select the "bEEP" item from the menu.
2. Confirm the selection.