Bimar VM43 Folleto De Instrucciones página 17

 If
fixed in
to be installed so that switches and other controls cannot be touched by a
person in the bath or shower.
 Warning: don't use wet hand touch the working machine and don't cover the
wind outlet and inlet.
 Before each use, verify that the heater is in good condition and that the
electrical cord is not damaged: in the case of doubt, ask for professionally
qualified help.
 Make sure that the cable is correctly positioned and that it is not in contact
with hot parts or sharp edges, nor wrapped around the device or twisted.
 The power socket must be easy to reach so the plug can be removed quickly in
case of emergency.
Use
Attention: the fan can be used only when completely and correctly assembled,
that is complete with its base.
Before each use, verify that the unit is in good condition, the electric cord is not
damaged, if the power cord is damaged, it must be replaced by the manufacturer
or a competent qualified electrician or a person with similar qualifications, in
order to avoid any risk.
The fan's functions can be controlled either with the keypad located on the
control panel or with the remote control. The remote control must be pointed at
the control panel; for the first use take off the tab transparent plastic of the
batteri's side (type AAA).
Insert the plug in the socket.
Ventilation:
1) To turn the fan on, press the "ON/SPEED" key on the remote control or the
control panel.
2) To select the desired speed in normal mode "
"ON-SPEED" key: on the control panel shows the selected speed
(Low=minimum, Med=medium, Hi=maximum) and "
Horizontal oscillation (right-left): this is controlled by the "OSCIL" key on the
remote control or the pushbutton panel (14). To eliminate this motion, press the
"OSCIL" key again.
Vertical inclination (high-low): it is regulated by gripping the motor body and
orienting it in the direction desired; throught the screw (10) to lock the body in
the desired position.
Timer: this function allows setting the operating time and the fan will
automatically stop at the end.
 To set the operating time, repeatedly press the "TIMER" key on the remote
control: every time the key is pressed, the time set is changed and the indicator
light on the control panel lights corresponding to the time selected (0.5 hour, 1
a bathroom shall state
NOR
17/48
that the heater
", repeatedly press the
NOR
".
is