Back Panel - Conceptronic C300APRA2 Guía De Instalación Rápida

ENGLISH
* In normal use, the Power LED will turn red and become green within 15 seconds after the device is
powered on or restarted. The LAN LED's will burn steady for about 15 seconds after which the active
LAN LED's will start to blink. Should this not be the case, the system has failed to boot.
You can use the following options to solve a system failure:
a. Power down the device, wait 10 seconds and reconnect the power to the device.
b. Reset the device to factory defaults by pressing the reset button on the back of the device for
+/- 15 seconds.
If the Power LED does not turn green after you tried above options, please contact Conceptronic
Support through www.conceptronic.net/support.
7 1
Nr Description
1. Antenna connections
2. DSL port
3. LAN ports (1 – 4)
4. Reset button
5. Power connector
6. Power button
Not visible (on the side of the router):
7. WPS button
Note: This Quick Installation Guide only explains the basic steps to get the C300APRA2 up and running.
For more info about the various functions of the C300APRA2, please refer to the User Manual
(English only) on the Product CD-ROM. Select "View User Manual" from the Autorun Menu.
26
2 3

Back Panel

1
Explanation
3x reverse-SMA connector for wireless antenna
Connect your ADSL line to the device
Connect your computer(s) to the device
Reset the device to the factory default settings
Connect the power supply to the device
Turn the device on or off
Start WPS Push Button configuration
6 5 6 1